HP MSR Series Configuration Manual page 121

[RouterB] bfd session init-mode active
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] ospf bfd enable
[RouterB-Ethernet1/1] bfd min-transmit-interval 500
[RouterB-Ethernet1/1] bfd min-receive-interval 500
[RouterB-Ethernet1/1] bfd detect-multiplier 6
4. Verify the configuration:
The following operations are performed on Router A. The operations on Router B and Router C are
similar. (Details not shown.)
# Display BFD information on Router A.
<RouterA> display bfd session
Total Session Num: 1
Session Working Under Ctrl Mode:
LD/RD
3/1
# Display routes to 120.1.1.0/24 on Router A, and you can see that Router A communicates with
Router B through the Layer 2 switch.
<RouterA> display ip routing-table 120.1.1.0 verbose
Routing Table : Public
Summary Count : 2
Destination: 120.1.1.0/24
Protocol: OSPF
Preference: 0
IpPrecedence:
NextHop: 192.168.0.100
BkNextHop: 0.0.0.0
RelyNextHop: 0.0.0.0
Tunnel ID: 0x0
BKTunnel ID: 0x0
State: Active Adv
Tag: 0
Destination: 120.1.1.0/24
Protocol: OSPF
Preference: 10
IpPrecedence:
NextHop: 10.1.1.100
BkNextHop: 0.0.0.0
RelyNextHop: 0.0.0.0
Tunnel ID: 0x0
BKTunnel ID: 0x0
State: Invalid Adv
Tag: 0
# Enable BFD debugging on Router A.
<RouterA> debugging bfd scm
<RouterA> debugging bfd event
<RouterA> debugging ospf event bfd
<RouterA> terminal debugging
Init Mode: Active
SourceAddr DestAddr
192.168.0.102 192.168.0.100
Process ID: 0
Interface: Ethernet1/1
BkInterface:
Neighbor : 0.0.0.0
Process ID: 1
Interface: Ethernet1/2
BkInterface:
Neighbor : 0.0.0.0
109
State Holdtime Interface
Up
Cost: 2
QosLcId:
Label: NULL
BKLabel: NULL
Age: 00h58m10s
Cost: 4
QosLcId:
Label: NULL
BKLabel: NULL
Age: 00h58m05s
1700ms Eth1/1