Ospf Configuration Task List - HP MSR Series Configuration Manual

RFC 3630, Traffic Engineering Extensions to OSPF Version 2
•
• RFC 481 1, OSPF Out-of-Band LSDB Resynchronization
RFC 4812, OSPF Restart Signaling
•
RFC 4813, OSPF Link-Local Signaling
•

OSPF configuration task list

To run OSPF in a routing domain, you must first enable OSPF on the routers. Make a proper configuration
plan to avoid wrong settings that can result in route blocking and routing loops.
Complete the following tasks to configure OSPF:
Task
Enabling OSPF
Configuring OSPF areas
Configuring OSPF
network types
Configuring OSPF route
control
Tuning and optimizing
OSPF networks
Configuring a stub area
Configuring an NSSA area
Configuring a virtual link
Configuring the broadcast network type for an interface
Configuring the NBMA network type for an interface
Configuring the P2MP network type for an interface
Configuring the P2P network type for an interface
Configuring OSPF route summarization
Configuring OSPF inbound route filtering
Configuring ABR Type-3 LSA filtering
Configuring an OSPF cost for an interface
Configuring the maximum number of ECMP routes
Configuring OSPF preference
Configuring OSPF route redistribution
Advertising a host route
Configuring OSPF packet timers
Specifying LSA transmission delay
Specifying SPF calculation interval
Specifying the LSA arrival interval
Specifying the LSA generation interval
Disabling interfaces from receiving and sending OSPF
packets
Configuring stub routers
Configuring OSPF authentication
Adding the interface MTU into DD packets
Configuring the maximum number of external LSAs in LSDB
61
Remarks
Required.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.