Getting Started; Battery Installation - Remote Control - VTech Toot-Toot Drivers RemoteControl Racer User Manual

GETTING STARTED

BATTERY INSTALLATION – VEHICLE
1. Make sure the unit is turned OFF.
2. Locate the batter y cover on
the back of the race car. Use a
screwdriver to loosen the screw.
3. Install 3 new AAA (AM-4/LR03)
batteries following the diagram
inside the batter y box. (The
use of new alkaline batteries
is recommended for maximum
performance.)
4. Replace the battery cover and tighten the screw to secure.

BATTERY INSTALLATION - REMOTE CONTROL

1. Locate the battery cover on the back of
the remote control. Use a screwdriver to
loosen the screw.
2. Install 2 new AAA (AM-4/LR03)
batteries following the diagram inside
the battery box. (The use of new alkaline
batteries is recommended for maximum
performance.)
3. Replace the battery cover and tighten
the screw to secure.
4