Getting Started; Battery Removal And Installation - VTech SHAKE IT BLUEY Instruction Manual

GETTING STARTED

Battery Removal and Installation

1. Make sure the unit is turned Off.
2. Find the battery cover located on the
back of Bluey's head, use a screwdriver
to loosen the screw, and then open the
battery cover.
3. Remove old batteries by pulling up on one end of each battery.
4. Install 2 new AAA (AM-4/LR03) batteries following the diagram
inside the battery box. (For best performance, alkaline batteries or
fully charged Ni-MH rechargeable batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un
adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
5