GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located
on the bottom of the unit, use a
screwdriver to loosen the screw
and then open the battery cover.
3. Remove old battery by pulling up
on one end of each battery.
4. Install 1 new AAA (LR03/AM-4)
battery following the diagram
inside the battery box. (For best
performance, alkaline batteries or
fully charged Ni-MH rechargeable
batteries are recommended.)
5. Replace the battery cover and tighten the screw to secure.
Note: If there is no response when the T-Rex is switched on,
please install brand new battery and try switching the T-Rex on
again.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
4