Advertisement
Available languages
Available languages
OBJ_BUCH-2023-003.book Page 14 Monday, November 30, 2015 2:45 PM
14 | English
Right rotation: For driving in screws, push the rotational direction switch 7 left to the
stop.
Left Rotation: For loosening or unscrewing screws, push the rotational direction
switch 7 right to the stop.
Switching On and Off
Note: The power tool can only be switched on when the sliding switch 4 has been
pushed to the front position.
To start the machine, press the On/Off switch 9 and keep it pressed.
The power light 11 lights up when the On/Off switch 9 is slightly or completely
pressed, and allows the work area to be illuminated when lighting conditions are in-
sufficient.
To switch off the machine, release the On/Off switch 9.
When the drilling spindle is locked, do not press the On/Off switch 9 for more
than 15 seconds. Otherwise the power tool can be damaged.
Fully automatic spindle locking (Auto-lock)
When the On/Off switch 9 is not pressed, the drill spindle and thus the tool holder are
locked.
This enables screws to be screwed in, even when the battery is empty and allows for
the machine to be used as a screwdriver.
Temperature Dependent Overload Protection
When using as intended for, the power tool cannot be subject to overload. When the
load is too high or the allowable battery temperature of 65 °C is exceeded, the elec-
tronic control switches off the power tool until the temperature is in the optimum tem-
perature range again.
Working Advice
Apply the power tool to the screw only when it is switched off. Rotating tool in-
serts can slip off.
Maintenance and Service
Maintenance and Cleaning
Before any work on the machine (e. g., maintenance, tool change, etc.) as
well as during transport and storage, set the rotational direction switch to the
centre position. Unintentional actuation of the On/Off switch can lead to injuries.
1 609 92A 1VR | (30.11.15)
Bosch Power Tools
Advertisement
