Advertisement
Available languages
Available languages
OBJ_BUCH-2023-003.book Page 12 Monday, November 30, 2015 2:45 PM
12 | English
Battery Charging (see figure A)
Do not use other battery chargers. The supplied battery charger is designed for
the Lithium-Ion battery in your machine.
Observe the mains voltage! The voltage of the power supply must correspond
with the data given on the nameplate of the battery charger. Battery chargers
marked with 230 V can also be operated with 220 V.
Note: The battery is supplied partially charged. To ensure full capacity of the battery,
completely charge the battery in the battery charger before using your power tool for
the first time.
The lithium-ion battery can be charged at any time without reducing its service life. In-
terrupting the charging procedure does not damage the battery.
The lithium ion battery is protected against deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty, the machine is switched off by means
of a protective circuit: The inserted tool no longer rotates.
Do not continue to press the On/Off switch after the machine has been auto-
matically switched off. The battery can be damaged.
The battery is equipped with a NTC temperature control which allows charging only
within a temperature range of between 0 °C and 45 °C. A long battery service life is
achieved in this manner.
The charging procedure begins as soon as the mains plug of the battery charger is
plugged into a socket outlet and the charge connector 13 is plugged into the socket 8
on the bottom of the handle.
Due to the intelligent charging method, the charging condition of the battery is auto-
matically detected and the battery is charged with the optimum charging current, de-
pending on battery temperature and voltage.
During the charging procedure, the handle of the machine warms up. This is normal.
Disconnect the battery charger from the mains supply when not using it for longer pe-
riods.
Additionally, the battery can also be recharged via a USB port. For this, connect the
power tool to a USB port using the micro USB cable (accessory).The charge duration
varies depending on the charging current.
The power tool cannot be used during the charge procedure; it is not defective when
inoperative during the charging procedure.
Observe the notes for disposal.
1 609 92A 1VR | (30.11.15)
Bosch Power Tools
Advertisement
