Bosch GSR BitDrive Original Instructions Manual page 13

OBJ_BUCH-2023-003.book Page 13 Monday, November 30, 2015 2:45 PM
Inserting Screwdriver Bits into the Bit Magazine (see figure B–C)
 When changing the application tool, wear safety goggles. Do not stare direct-
ly into the tool holder. When changing the tool insert, it can be thrown out toward
the front.
 Only insert one screwdriver bit per chamber into the bit magazine. Use only
short standard screwdriver bits. Longer screwdriver bits cannot be loaded into
the bit magazine.
– Turn the bit magazine 10 until an empty chamber can be seen in viewing window 3.
– Push the sliding switch 4 toward the front.
– Insert the screwdriver bit 1 directly into the tool holder 2.
– Push the sliding switch 4 to the rear to load the screwdriver bit 1 into bit magazine
10.
– As soon as you push the sliding switch 4 to the rear or actuate the On/Off switch 9
when in the rear position, the bit magazine 10 is illuminated for approx. 20 sec-
onds.
Changing the Tool (see figure D)
 When changing the application tool, wear safety goggles. Do not stare direct-
ly into the tool holder. When changing the tool insert, it can be thrown out toward
the front.
– Turn the bit magazine 10 until the desired screwdriver bit 1 can be seen in viewing
window 3.
– Push the sliding switch 4 toward the front.
Operation
Starting Operation
Reversing the rotational direction (see figure E)
The rotational direction switch 7 is used to reverse the rotational direction of the ma-
chine. However, this is not possible with the On/Off switch 9 actuated.
Bosch Power Tools
English | 13
1 609 92A 1VR | (30.11.15)