Configuring Basic Snmpv1 Functions - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Applicable Environment
SNMP needs to be deployed in a network to allow the NM station to manage network devices.
If the network has a few devices and its security is good, such as a campus network or a small
enterprise network, SNMPv1 can be deployed to ensure the normal communication between the
NM station and managed devices.
Pre-configuration Tasks
Before configuring a device to communicate with an NM station by running SNMPv1, complete
the following task:
l
Data Preparation
Before configuring a device to communicate with an NM station by running SNMPv1, you need
the following data.
No.
1
2
3

1.2.2 Configuring Basic SNMPv1 Functions

After basic SNMP functions are configured, an NM station can perform basic operations such
as Get and Set operations on a managed device, and the managed device can send alarms to the
NM station.
Context
Steps 3, 4, and
configurations are complete, basic SNMP communication can be conducted between the NM
station and managed device.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 (Optional) Run:
snmp-agent
The SNMP agent function is enabled.
Issue 01 (2012-03-15)
Configuring a routing protocol to ensure that the switch and NM station are routable
Data
SNMP version, SNMP community name, destination address of alarm messages,
administrator's contact information and location, and the maximum SNMP packet
size
(Optional) ACL number, IP address of the NM station, and MIB object
(Optional) Name of the alarm-sending module, source address of trap messages,
queue length for trap messages, and lifetime of trap messages
5 are mandatory for the configuration of basic SNMP functions. After the
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SNMP Configuration
8