Creating A Cluster - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
l
l
----End

3.3.4 Creating a Cluster

To perform unified management over switches, you must first create a cluster and add switches
to be managed to the cluster.
Procedure
l
Issue 01 (2012-03-15)
1. Run:
system-view
The system view is displayed.
2. Run:
ntdp timer hop-delay hop-delay-time
The hop delay in forwarding NTDP packets is set.
3. Run:
ntdp timer port-delay port-delay-time
The interface delay in forwarding NTDP packets is set.
By default, the hop delay is 200 ms and the interface delay is 20 ms.
(Optional) Setting the interval for collecting topology information
1. Run:
system-view
The system view is displayed.
2. Run:
ntdp timer interval
The interval for collecting topology information is set.
By default, the interval for collecting topology information is set to 0 minutes, that is,
topology information is not collected regularly.
(Optional) Enabling topology collection
1. Run the following command in the user view:
ntdp explore
Topology collection is enabled.
You can run this command to collect topology information at any time.
Configuring a management VLAN
Do as follows on the administrator switch and member switches:
1. Run:
system-view
The system view is displayed.
2. Run:
vlan vlan-id
A VLAN is created and the VLAN view is displayed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 HGMP Configuration
88