Configuring The Transit For A Static Lsp; Configuring The Egress For A Static Lsp; Checking The Configuration - Huawei Quidway S9300 series Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - MPLS
The LSR is configured as the ingress on the specified LSP.
----End

1.3.3 Configuring the Transit for a Static LSP

To set up a static LSP, you need to configure the transit node.
Context
Do as follows on the LSR to be configured as a transit node:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
static-lsp transit lsp-name incoming-interface interface-type interface-number in-
label in-label { nexthop next-hop-address | outgoing-interface interface-type
interface-number } out-label out-label
The LSR is configured as the transit node on the specified LSP.
----End

1.3.4 Configuring the Egress for a Static LSP

To set up a static LSP, you need to configure the egress node.
Context
Do as follows on the LSR to be configured as the egress:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
static-lsp egress lsp-name incoming-interface interface-type interface-number in-
label in-label [ lsrid ingress-lsr-id tunnel-id tunnel-id ]
The LSR is configured as the egress on the specified LSP.
----End

1.3.5 Checking the Configuration

After a static LSP is set up, you can view that the static LSP is Up and the route status is Ready.
Issue 04 (2011-12-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Static LSPs Configuration
4