Example For Configuring The Interconnection Of Ftp Servers And Devices In And Out Of The Hgmp Cluster (In Nat Mode) - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
3.6.2 Example for Configuring the Interconnection of FTP Servers
and Devices in and out of the HGMP Cluster (in NAT Mode)
Networking Requirements
As shown in
the administrator switch of the cluster and other switches are member switches. The member ID
of Member-1 is 1, the member ID of Member-2 is 2 and the member ID of Member-3 is 3.
To upload files to Member-1, Member-2, and Member-3 or download files from them, you can
set up an FTP connection between the devices out of the cluster and member switches in NAT
or non-NAT mode.
Issue 01 (2012-03-15)
ntdp timer 10
ndp enable
#
interface Vlanif10
#
interface GigabitEthernet1/0/1
port link-type trunk
port trunk allow-pass vlan 10
ntdp enable
ndp enable
#
cluster
mngvlanid 10
administrator-address 0001-0001-0001 name HUAWEI
#
return
Figure 3-4, all the Layer 2 switches belong to the same cluster. Administrator-1 is
NOTE
In this configuration example where the NAT mode is adopted, Member-3 accesses the FTP server
(2.0.0.1/8) out of the cluster and devices out of the cluster access the FTP server (Member-2) in the cluster.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 HGMP Configuration
118