Example For Configuring Security Features For An Hgmp Cluster - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
l
3.6.10 Example for Configuring Security Features for an HGMP
Cluster
Networking Requirements
As shown in
is the administrator switch of the cluster and other switches are member switches. The member
ID of Member-2 is 2 and the member ID of Member-3 is 3.
Disable NDP and NTDP on the interfaces of all the member switches that do not need NDP or
NTDP. To perform the action and improve the security of the cluster, you can configure security
features for the HGMP cluster.
Issue 01 (2012-03-15)
#
vlan batch 10
#
cluster enable
ntdp enable
ntdp hop 3
ntdp timer 10
ndp enable
#
interface Vlanif10
#
interface GigabitEthernet1/0/1
port link-type trunk
port trunk allow-pass vlan 10
ntdp enable
ndp enable
#
cluster
mngvlanid 10
administrator-address 0001-0001-0001 name HUAWEI
#
return
Configuration file of Member-3.
#
sysname Member-3
#
vlan batch 10
#
cluster enable
ntdp enable
ntdp hop 3
ntdp timer 10
ndp enable
#
interface Vlanif10
#
interface GigabitEthernet1/0/1
port link-type trunk
port trunk allow-pass vlan 10
ntdp enable
ndp enable
#
cluster
mngvlanid 10
administrator-address 0001-0001-0001 name HUAWEI
#
return
Figure 3-12, all the Layer 2 switches belong to the same cluster. Administrator-1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 HGMP Configuration
200