C2 Heaters Temperature; C3 Drying Time Per Pass - Epson SC-S30600 Technical Manual

Now w, run the Sec condary mea
serie es. From you r own appre
patte ern (top & bo ottom squar
Seco ondary A
7
Inpu ut Number
Ran ge: 51‐13
[OK ] Done
C 2. Heaters t temperatur
Hea ater Temper rature
| 40°C | 40°C | 45°C
Curr rent: 40, 40, , 45° C
[OK ] Done [↖] ] Back
The heaters setti ings have an
qual ity. If you set t wrong heat
a) co olor consisten ncy issues
b) M Media bucklin ng head ru
To se et the best h heater setting
Med ia Vendors.
Tip ps : If you wis h to optimise
C 3. Drying T ime per Pas
Dryi ing Time Pe er Pass
0.0 sec
Ran ge : 0.0‐10. sec
Curr rent: L0.0 se ec
[OK ] Done [↖] ] Back
This setting will d drastically ex
each h print pass. Use this sett
Epso n Engineering g Europe
asurement. T The printed p
eciation, inpu ut the lightes
re) is the n°2 .
re
important i nfluence on
ters settings , you may fa
ubbing / hea d strikes
gs, please ch heck on the M
the printing q quality, try to
ss
xtend the pri inting time. I
ting only if ne eeded for sp
SC‐S306
pattern is a 6 6 lines x 13 r
st pattern us ing the pane
the chromat tic sensation
ace :
Media Vendo or Web Site.
use different heaters settin
If you set 0.5 5sec, the car
pecific applic ation.
600/610 Tech nical Guide
ows of Light Grey / dark
el below. In o our example,
n and more im mportant, on
You'll find in n the annexe
ngs to reach th he best print o
riage will sto op the set va
grey square
, the lightest t
n the print
es a list of ma ain
output
lue between n
P a g e | 13