Refilling And Volume Regulation Of Transmission Lubricant - Chery QQ6 Service Manual

Follow by installation of screw of reverse gear idler shaft. Align the screw of reverse gear idler shaft
with the threaded hole on the idler shaft, and then tighten it with the tightening torque as 38±2.5Nm; after
that, tighten bleeding plug with tightening torque as 44±3Nm; finally, install oil limit plug onto the
transmission, but do not tighten it then. See Figure 34.
Screw of reverse gear idler shaft (with
tightening torque as 38±2.5Nm)

10. Refilling and volume regulation of transmission lubricant

After the transmission is installed onto the vehicle, park the vehicle on a flat road surface, then use the
tool for refilling to refill transmission lubricant. The lubricant refilled should at least conform to API GL-4
SAE 75W-90 specification. Refill through installation hole of speed sensor as shown in Figure 35 with the
refilling volume as 1.8L. after refilling, open the oil limit plug to regulate the lubricant to specified volume,
and then tighten the oil limit plug with the tightening torque as 44±3Nm.
Figure 33
Figure 34
32
Bleeding plug (with tightening torque
as 44±3Nm)
Oil-Limiting Plug