Chery QQ6 Service Manual page 31

Assemble transmission housing and clutch housing together and then fasten them with connecting bolts.
Before fastening, apply thread locking glue (262 type anaerobic adhesive) on the bolts properly. Tighten
the diagonal bolts first as possible to ensure favorable fastening and sealing effects, and the tightening torque
for the bolts are 25±2Nm. Note: the two connecting bolts at oil drain hole are a little longer than other
connecting bolts, and the bracket should be installed first. See Figure 31.
Bracket
To install the assembled gearshift mechanism assembly onto the transmission, clean the junction part of
gearshift housing and transmission housing and apply sealant on it (oil resistance silicone sealant,
HZ1213Q/320222 YAP02-92), align one end of gearshift shaft with the linear bearing inside the transmission
and align the locating hole on gearshift housing with the locating pin on transmission housing, and then
tighten the connecting bolts of gearshift housing and transmission housing with the tightening torque as
25±2Nm. See Figure 32.
Connecting bolt of transmission and clutch housings (13)
Reverse gear rocker arm bracket bolt
(with tightening torque as 25±2Nm)
The two connecting
bolts are longer
Figure 31
30