Siemens SIMATIC ET 200SP Manual page 13

Selecting, installing and connecting BaseUnits
See the System Manual ET 200SP distributed I/O system
(http://support.automation.siemens.com/WW/view/en/58649293)
Personal injury or damage to equipment is possible.
Connecting a rated supply voltage to the BaseUnit higher than the one given in the
technical specifications may lead to dangerous situations in your plant or cause defects in
ET 200SP components.
Therefore, only connect the rated supply voltage given in the technical specifications to the
BaseUnit.
The connected rated supply voltage must correspond to the rated supply voltage of the I/O
modules in the potential group.
When mains voltage is connected to the BaseUnit, you must ensure that all other supply
voltages on this BaseUnit use the same phase as the mains.
The Totally Integrated Automation Selection Tool (TIA Selection Tool)
(http://www.siemens.com/tia-selection-tool) supports you in selecting, configuring and
ordering the ET 200SP modules. This tool can be downloaded free of charge from the
Internet (http://support.automation.siemens.com/WW/view/en/58649293).
Hazardous Voltage (when using ET 200SP motor starters)
Can Cause Death, Serious Injury, or Property Damage.
Proper use of hardware products
This equipment is only allowed to be used for the applications described in the catalog and
in the technical description, and only in conjunction with non-Siemens equipment and
components recommended by Siemens.
Correct transport, storage, installation and assembly, as well as careful operation and
maintenance, are required to ensure that the product operates safely and without faults.
EU note: Start-up/commissioning is absolutely prohibited until it has been ensured that the
machine in which the component described here is to be installed fulfills the
regulations/specifications of Machinery Directive 2006/42/EC.
BaseUnits (6ES7193-6BP.../3RK1908-0AP00...)
Manual, 12/2016, A5E03727049-AG
WARNING
WARNING
Product overview
13