Table of Contents
Advertisement
About your Rinnai Neo
Congratulations on the purchase of your Rinnai Neo gas fireplace. The Neo range
combines modern good looks with the latest advances in technology.
Convection fan helps to
circulate heat more efficiently
Control panel
Up to 6.94 kW heat output—will
warm large areas
Mix and match from a range
of framing options
A choice of contemporary
and classic framing options
are available—has the added
benefit of being able to
interchange the frames at a
later stage.
Contemporary frame
Child lock function
Neo ETR models have a built-
in child lock function that
requires pressing two buttons
at the same time to operate the
appliance. This function cannot
be overridden. To turn the
controller on, press PWR and
OK at the same time. To turn
the controller off, press PWR.
General description
Your Neo is a burning log effect,
gas fire with a natural draft
combustion system, intended
for use with NG and ULPG.
4 | Neo operation guide: 11907-E 05-14
Temperature control is
achieved by pressing the up
or down arrows on the manual
control panel or via the wireless
controller.
This heater has an electronic
ignition with intermittent pilot.
The pilot is only on when the
heater is in operation.
Air for combustion is drawn
Premium Classic
from the room. By-products
frame (inbuilt
of combustion are exhausted
models only)
via the flue discharge vent
when installed in a masonry
chimney, or when installed in
a zero clearance box or as a
freestanding unit, through a
100 mm x 150 mm flue to the
outside of the house.
This appliance is modular and
consists of an 'engine' that
is utilised in any of the three
configuration types as listed.
Fireplace: Masonry
installation
The appliance is directly
mounted into an existing
The intelligent electronic timer remote (ETR)
provides unmatched control of your appliance.
A glass dress guard creates
protection without obstructing
the view
Mix and match from a range of
framing options
Low standby power, less than
3 W
masonry fire place or a non-
combustible masonry enclosure
that has a chimney.
Zero clearance (mock
chimney) installation
The appliance is fitted within
a zero clearance box then
inserted into a wall or other
suitable structure.
Freestanding installation:
Plinth or console
The appliance is housed in a
decorative fabricated sheet
metal box that is intended to be
freestanding and not inbuilt.
Advertisement
Table of Contents
