VINCENT SA-32 Instructions For Use Manual page 32

CONNECTION OF ONE OR MORE POWER AMPLIFIERS
You can as well use all three stereo outputs at the same time, giving way for up to 6 main amplifier chan-
nels to supply their loudspeaker. For that all you need to do is connect all remaining stereo outputs (12)
with additional main amplifier channel inputs.
SA-32
The fact that this amplifier is equipped with two RCA stereo preamplifier outputs enables you to biamp
your loudspeakers using adequate speakers and one or more additional main amplifiers. Your HiFi spe-
cialist will advise you on this.
CONNECTION OF THE POWER CABLE
Check whether the wall socket provides the appropriate mains power, which is the case if it is supplied with
230 V AC 50 Hz. Push the plug on the power cable supplied firmly into the power socket on the back of the
appliance. Plug the other end of the power cable into a mains socket.
This device is equipped with a switch (14) that can be used to change the country-specific voltage from
230 V to 110 V.
Please never actuate the switch during operation! The voltage must only be switched by a techni-
cian, since the device fuse must also be replaced after actuation of the switch! Information about
the device fuse can be found on the back of the device.
Unauthorised actuation of the switch will void any warranty claim!
Vincent
32
S3 S4
S2 S5
S1 S6
XLR OUT
SWITCHING THE VOLT GE
XLR connection
XLR IN
Stereo main amplifier