APRILIA Atlantic 300 Service Station Manual page 229

ATLANTIC 300 i.e.
Removal
BRAKEFORCE DISTRIBUTION MECHANISM
REMOVAL
•
Remove the instrument panel.
•
Drain off the braking system.
•
Undo and remove the two screws «1»
and the bleed valve, and collect the rel-
evant gaskets.
•
Remove the brake pipes and protect
them to avoid brake fluid spilling.
•
Unscrew and remove the two screws
«2» fixing the brakeforce distribution
mechanism.
•
Remove the brakeforce distribution
mechanism.
NOTE
MARK THE BRAKE PIPES TO PREVENT INCORRECT RE-
FITTING.
NOTE
UPON REFITTING PURGE THE AIR OF THE BRAKING SYS-
TEM.
Locking torques (N*m)
Screw fixing the brakeforce distribution mechanism to curved support 12 ± 20% (8.9 ftlb)
REAR BRAKE PUMP REMOVAL
•
Remove the left switch.
•
Undo and remove the two screws «1».
•
Remove the brake pump U-bolt.
•
Remove the brake pump; keep it con-
nected to the brake pipe.
Remove the brake pump completely, if necessary:
•
Disconnect the two rear stop switch
connectors «2».
•
Drain off the braking system.
•
Undo and remove the screw «3» and
collect the sealing washers.
•
Remove the brake pump.
Locking torques (N*m)
Screw fixing brake pumps to handlebar 10 ± 20% (7.4 ftlb)
Braking system
BRAK SYS - 229