Table of Contents
Advertisement
Panel Descriptions
Mixer Section
This is a four-channel mixer. Here you can adjust the sound, connect sounds, and turn headphone cue on/off.
1
2
3
4
5
6
7
1
[1], [2] assign buttons
Turn on/off the effect specified by the effect
section.
2
[TRIM] knobs
Adjust the volume.
3
[HI], [MID], [LOW] knobs
Boost/cut the volume of the high-frequency,
mid-frequency, and low-frequency regions.
Effect Section
Here you can adjust the effects using two independent effect sections (FX1, FX2).
1
3
1
Effect parameter knobs
Adjust the character of the specified effect.
[SHIFT] + Effect
Changes the effect type.
parameter knob
2
[BEATS] knob
Adjusts the time for which the effect is applied.
6
1
9
3
3
10
4
4
11
12
13
8
4
Channel level indicators
Indicate the level of each channel before the
sound passes through the channel fader.
5
[FX] knobs
Adjust the effect that is selected by [CHANNEL
FX] buttons.
2
4
3
Effect buttons
Turn the effect on/off.
[SHIFT] +
Effect button
14
2
3
4
5
6
7
1
3
Changes the effect type.
6
Channel [CUE] buttons
Turn cue on/off for each channel. The sound of
channels whose [CUE] button is lit is output from
the headphones.
The AUTO PITCH of the VT section
[SHIFT] + [CUE]
operates according to the key
information of the selected channel.
7
Channel faders
Adjust the output level of each channel.
8
Cross fader
Outputs the sounds that are assigned by the
front panel [CROSS FADER] assign switches.
9
[MASTER LEVEL] knob
Adjusts the master output level.
10
Master level indicator
Indicates the master output level.
11
[CHANNEL FX] buttons
Select the type of channel effect.
[DUB ECHO]
Adds delayed sound.
[JET]
Applies a flanger effect.
[NOISE]
Adds noise.
[FILTER]
Applies a filter.
12
TR/SAMPLER [CUE] button
Turns TR/SAMPLER output cue on/off.
13
TR/SAMPLER level fader
Adjusts the output level of the TR section and
sampler.
14
[BOOTH MONITOR] knob
Adjusts the output level of the BOOTH OUT jacks.
2
4
4
[TAP] button
The interval at which you press this button (tap
tempo) specifies the reference tempo of the
effect.
If you long-press the button, the specified
tempo is reset.
[SHIFT] + [TAP]
Switches the effect mode.
Advertisement
Table of Contents
