Frymaster FilterQuick FQG30-T Installation, Operation And Maintenance Manual page 45

Code
E35 RETURN VALVE NOT CLOSED - FILTRATION
AND TOP OFF DISABLED - CALL SERVICE
E36 VALVE INTERFACE BOARD FAILURE -
FILTRATION AND TOP OFF DISABLED - CALL
SERVICE
E37 AUTOMATIC INTERMITTENT FILTRATION
PROBE FAILURE - FILTRATION DISABLED - CALL
SERVICE
E39 CHANGE FILTER PAD
E41 OIL IN PAN ERROR
E42 CLOGGED DRAIN (Gas)
E43 OIL SENSOR FAILURE - CALL SERVICE
E44 RECOVERY FAULT
E45 RECOVERY FAULT – CALL SERVICE
E46 SYSTEM INTERFACE BOARD 1 MISSING - CALL
SERVICE
E51 DUPLICATE BOARD ID - CALL SERVICE
E52 USER INTERFACE CONTROLLER ERROR - CALL
SERVICE
E53 CAN BUS ERROR - CALL SERVICE
E54 USB ERROR
E55 SYSTEM INTERFACE BOARD 2 MISSING - CALL
SERVICE
E61 MISCONFIGURED ENERGY TYPE
E62 VAT NOT HEATING – CHECK ENERGY SOURCE –
XXXF OR XXXC
E63 RATE OF RISE
E64 FILTRATION INTERFACE BOARD FAILURE -
FILTRATION AND TOP OFF DISABLED - CALL
SERVICE
ERROR MESSAGE
Return valve was trying to close and
confirmation is missing
Valve Interface Board connections lost or
board failure. Call service.
AIF RTD reading out of range. Call service.
25-hour timer has expired or dirty filter
logic has activated. Change the filter paper
or pad.
The system detects that oil may be present
in the filter pan.
Vat did not empty during filtration. Ensure
the drain is not clogged and follow
prompts.
Oil level sensor may have failed. Call
service.
Recovery time exceeded maximum time
limit.
Recovery time exceeded maximum time
limit for two or more cycles. Call service.
SIB board 1 connection lost or board
failure. Call service.
Two or more controllers have the same
location ID. Call service.
The controller has an unknown error. Call
service.
Communications are lost between boards.
Call service.
USB connection lost during an update.
SIB board 2 connection lost or board
failure. Call service.
The fryer is configured for the incorrect
energy type. Call service.
The vat is not heating properly.
Rate of rise error occurred during a
recovery test. Ensure the oil level is at the
bottom oil level when cold and at the top
oil level line when at setpoint. On electric
fryers ensure the probe is not touching the
elements.
Filtration Interface Board connections lost
or board failure. Call service.
5-9
EXPLANATION