Frymaster FilterQuick FQG30-T Installation, Operation And Maintenance Manual page 2

IF, DURING THE WARRANTY PERIOD, THE CUSTOMER USES A PART FOR THIS FRYMASTER EQUIPMENT OTHER THAN AN
UNMODIFIED NEW OR RECYCLED PART PURCHASED DIRECTLY FROM FRYMASTER DEAN, OR ANY OF ITS AUTHORIZED SERVICERS,
AND/OR THE PART BEING USED IS MODIFIED FROM ITS ORIGINAL CONFIGURATION, THIS WARRANTY WILL BE VOID. FURTHER,
FRYMASTER DEAN AND ITS AFFILIATES WILL NOT BE LIABLE FOR ANY CLAIMS, DAMAGES OR EXPENSES INCURRED BY THE
CUSTOMER WHICH ARISE DIRECTLY OR INDIRECTLY, IN WHOLE OR IN PART, DUE TO THE INSTALLATION OF ANY MODIFIED PART
AND/OR PART RECEIVED FROM AN UNAUTHORIZED SERVICER.
This appliance is intended for professional use only and is to be operated by qualified personnel only. A Frymaster DEAN
Factory Authorized Servicer (FAS) or other qualified professional should perform installation, maintenance, and repairs.
Installation, maintenance, or repairs by unqualified personnel may void the manufacturer's warranty. See Chapter 1 of this
manual for definitions of qualified personnel.
This equipment must be installed in accordance with the appropriate national and local codes of the country and/or region in
which the appliance is installed. For the United States and Canada these are the National Fuel Gas Code, ANSI Z233.1/NFPA
54, or the Natural Gas and Propane Installation Code, CSA B149.1. See NATIONAL CODE REQUIREMENTS in Chapter 2 of this
manual for specifics.
The gas manifold of this appliance or of the battery of which it is a part must be connected to a gas appliance pressure
regulator adjusted for the manifold pressure marked on the rating plate.
The appliance and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure
testing of that system at test pressures in excess of ½ psi (3.5 kPa/13.84 inches W.C.).
The appliance must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any
pressure testing of the gas supply piping system at test pressures equal to or less than ½ psi (3.5 kPa/13.84 inches W.C.).
This equipment is to be installed in compliance with the basic plumbing code of the Building Officials and Code
Administrators International, Inc. (BOCA) and the Food Service Sanitation Manual of the U.S. Food and Drug Administration.
Drawings and photos used in this manual are intended to illustrate operational, cleaning and technical procedures and may
not conform to onsite management operational procedures.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) This device
may not cause harmful interference, and 2) This device must accept any interference received, including interference
that may cause undesired operation. While this device is a verified Class A device, it has been shown to meet the Class B
limits.
This digital apparatus does not exceed the Class A or B limits for radio noise emissions as set out by the ICES-003 standard
Improper installation, adjustment, maintenance or service, and unauthorized alterations or modifications can cause
property damage, injury, or death. Read the installation, operating, and service instructions thoroughly before installing
or servicing this equipment. Only qualified service personnel may convert this appliance to use a gas other than that for
which it was originally configured.
No structural material on the fryer should be altered or removed to accommodate placement of the fryer under a hood.
Questions? Call the Frymaster Dean Service Hotline at 1-800-551-8633.
NOTICE
NOTICE
NOTICE
NOTICE TO U.S. CUSTOMERS
NOTICE
NOTICE
U.S.
CANADA
of the Canadian Department of Communications.
DANGER
DANGER