Table of Contents
Advertisement
Polar CS600 User Manual
software also allows you to make graphical comparisons with previous results. The Polar Fitness Test
results are downloaded automatically to the software when you download exercises using the Transfer
Data option.
1 0. USING A NEW ACCESSORY
Teaching
Your CS600 cycling computer has been synchronized, or "taught" to work together with the Polar
WearLink W.I.N.D. transmitter and to measure heart rate, speed and distance. In other words, your
cycling computer receives signals from your transmitter and speed sensor only, and enables
disturbance-free exercise in a group.
If you purchase a new transmitter, speed, cadence* or power* sensor as a separate accessory, they
have to be introduced to the cycling computer. This is called teaching and takes only a few seconds.
To prevent interference during a cycling event, make sure you perform the teaching process prior to the
event.
Teach New Transmitter
Wear the transmitter and make sure that you are not near (40 m/131 ft) other Polar WearLink W.I.N.D.
transmitters. In time mode, press OK. The cycling computer starts searching for the transmitter signal.
Once the new transmitter is identified,
• Select
to confirm teaching.
Yes
recording by pressing OK.
• Select
to cancel teaching.
No
Teach New Speed Sensor
Make sure that there are no other speed sensors or cycling computers nearby (40 m/131 ft). The
teaching procedure only takes a few seconds.
You can teach one Speed sensor for each bike setting.
Select
Settings > Bike > Bike1 > Speed > On/Off
Select
> On > Teach new sensor?
• Select
to confirm teaching >
Yes
activate the sensor. A flashing red light indicates that the sensor is activated.
and
Completed!
Exercise displays updated
speed and distance data.
• Select
to cancel teaching and the already earlier taught speed sensor is taken into use.
No
If you haven't taught speed sensor to recognize a certain bike before, speed information will not be shown.
Select >
and the display returns to the previous menu display.
Off
To return to time mode, press and hold the BACK button.
Once the speed sensor is taught to recognize the cycling computer, it will do so even if the sensor has been
turned off. When the speed sensor is turned back on
Exercise displays updated
Teach New Cadence Sensor*
Select
Settings > Bike > Bike1 > Cadence > On/Off
New WearLink found, Teach new WearLink?
and
Completed!
Exercise displays updated
is displayed
is displayed. Rotate the wheel a few times to
Start test drive
are displayed. The cycling computer is now ready to receive
Teach new sensor?
appears. If
is selected, the monitor goes into teaching mode.
Yes
is displayed.
are displayed. Start exercise
is displayed. Select
and
No
43
Advertisement
Table of Contents
