Table of Contents
Advertisement
ENGLISH
7. USING A NEW ACCESSORY
A new sensor purchased as a separate accessory has to be introduced to the cycling computer. This is
called teaching and takes only a few seconds. Teaching ensures that your cycling computer receives
signals from your sensor only, enabling disturbance-free exercise in a group. If you have purchased the
sensor and the cycling computer as a set, the sensor has already been "taught" to work together with the
cycling computer. You just need to activate the sensor in your cycling computer.
You can teach one speed, cadence and power sensor for each bike setting.
Teaching a New Speed Sensor
Select
>
Settings
Bike SET
• To teach a new sensor, make sure you are not near (40 m/131 ft) other speed sensors. To confirm
teaching, press OK.
Test drive
times. A flashing red light indicates that the sensor is activated.
process is over. The cycling computer is now ready to receive speed and distance data.
• If
is displayed, the cycling computer may be detecting the signal of more than one sensor
Teaching FAILED
or the sensor is not activated. Make sure you are not near (40 m/131 ft) other speed sensors and press
OK.
is displayed. Press OK and rotate the wheel a few times to activate the sensor.
Try again?
• If you want to cancel teaching, press
Teaching a New Cadence Sensor*
Select
>
Settings
Bike SET
• To teach a new sensor, make sure you are not near (40 m/131 ft) other cadence sensors. To confirm
teaching, press OK.
Test drive
times. A flashing red light indicates that the sensor is activated.
process is over. The cycling computer is now ready to receive cadence data.
• If
is displayed, the cycling computer may be detecting the signal of more than one sensor
Teaching FAILED
or the sensor is not activated. Make sure you are not near (40 m/131 ft) other cadence sensors and press
OK.
Try again?
is displayed. Press OK and rotate the crank a few times to activate the sensor.
• If you want to cancel teaching, press
Teaching a New Power Output Sensor*
Select
>
Settings
Bike SET
•
C. length
: Set chain length in millimeters. Accept the set value with OK.
•
: Set chain weight in grams. Accept the set value with OK.
C. weight
•
: Set span length in millimeters. Measure the distance from the centre of the rear hub to the
S. length
centre of the bottom bracket as shown in the picture. Accept the set value with OK.
Examples of chain weights and lengths (Due to the variation of the measurements, Polar cannot be held
responsible for their validity):
Shimano Dura-Ace CN-7700
Super narrow HG
26
Using a New Accessory
>
/
/
>
Bike1
2
3
Speed SET
is displayed. To activate the sensor, press OK and rotate the wheel a few
. The already taught speed sensor is taken into use.
STOP
>
/
/
>
Bike 1
2
3
Cadence SET
is displayed. To activate the sensor, press OK and rotate the crank a few
. The already taught cadence sensor is taken into use.
STOP
>
/
/
>
Bike 1
2
3
Power SET
Weight
280 g
>
.
is displayed
ON
Speed TEACH?
Completed!
>
.
ON
Cadence TEACH?
Completed!
>
.
ON
Length
1473 mm
is displayed once the teaching
is displayed
is displayed once the teaching
Advertisement
Table of Contents
