Devicenet Settings; Devicenet Communications Settings - Omron NJ501 Connection Manual

6. DeviceNet Settings

This section provides specifications such as communications parameters and variables that
are defined in this document.

6.1. DeviceNet Communications Settings

The following are the settings for DeviceNet.
Unit number
Node address (MAC ID)
Baud rate (bps)
Additional Information
To monitor the Safety Network Controller from the Controller, set the Controller as a Standard
Master and set the Safety Network Controller as a Standard Slave on DeviceNet.
Establish a connection between the Standard Master and the Standard Slave to monitor the
data. With the connection, not only Safety I/O communications but also standard I/O
communications are performed.
Standard Slave
Additional Information
When a DeviceNet Unit is used with a Controller, slave data are allocated to the memory
used for CJ-series Units. With programs, specify variable names for the memory used for
CJ-series Units.
With Sysmac Studio, add the prefix "%" to each address to indicate the memory used for
CJ-series Units.
CJ1W-DRM21
0
63
500 kbps
Machine Automation
Controller
Safety Network
Controller
6．DeviceNet Settings
NE1A-SCPU01-V1
-
0
500 kbps
Standard Master
Connection
6