Omron NJ501 Connection Manual page 26

7.4.2. Starting the Network Configurator and Creating the Network Configuration
Start the Network Configurator and create the network configuration.
Additional Information
To use the Safety Network Controller, Network Configurator for Safety (WS02-CFSC1-E) is
required. When the Network Configurator for Safety is installed, Network Configurator
provided with Sysmac Studio is overwritten.
When the Network Configurator for Safety is installed, the default network of the Network
Configurator changes from EtherNet/IP to DeviceNet.
1
Turn ON the power supply to the
Safety Network Controller.
2
Start the Network Configurator
by selecting OMRON Network
Configurator for CIP Safty v3 -
Network Configurator from the
Windows Menu.
*The menu names are the
default names at installation.
After installing the Network
Configurator for Safety, the
same menu names are also
displayed when starting the
Network Configurator that was
installed with the Sysmac
Studio.
The screen on the right is
displayed.
3
Select New - DeviceNet from
the File Menu.
Hardware List
Network Configuration Pane
7．Connection Procedure
23