Connecting The Terminal To Power Source - VeriFone VX 685 Installation Manual

Hide thumbs

Table Of Contents

Table of Contents

Connecting the

Terminal to

Power Source

WARNING

NOTE

To Connect the

VX 690 Terminal to

the Power Source

To Connect the

VX 685 Terminal to

the Power Source

The terminal is either powered by an external power pack or the single cell Li-ion

rechargeable battery, which can be charged in the terminal by the AC/DC power

pack through the micro-USB connector for VX 690 and pin connector for VX 685.

When you have finished installing the necessary cards and/or optional devices,

you are ready to connect the terminal to the power source.

Do not connect the terminal to the power supply until all peripherals are attached.

Using an incorrectly rated power supply can damage the unit or cause it not to

work properly. Use only a power pack with P/N PWR260-001-XX-A. See

Specifications

for detailed power supply specifications.

Do not plug the power pack into an outdoor outlet or operate the terminal

outdoors. Also, disconnecting power during a transaction can cause unstored

data files to be lost.

To protect against possible damage caused by lightning strikes and electrical

surges, VeriFone recommends installing a power surge protector.

When the terminal has power and an application is loaded, the application starts

after the initial VeriFone copyright screen. If no application is loaded,

appears on the display after the initial VeriFone copyright screen.

NEEDED

Insert the micro-USB connector to the micro-USB port found on the side of the

terminal.

Plug the AC power cord into a wall outlet or power surge protector.

Figure 10

Connecting VX 690 to Power Source

Insert the pin connector into the pin slot located at the back of the terminal.