Table of Contents
Advertisement
Installing/
Replacing MSAM
Cards
CAUTION
NOTE
To Install/Replace
MSAM
NOTE
Manual Startup
and Shutdown
Connecting the
VX 600 to a
Power Source
When you first receive your VX 600, you may need to install an MSAM card or you
may need to replace old cards.
Observe standard precautions when handling electrostatically sensitive devices.
Electrostatic discharges can damage this equipment. VeriFone recommends
using a grounded anti-static wrist strap.
Not all applications require the use of an MSAM card.
1
Unplug any cables or chargers from the VX 600. Using your finger, push the
MSAM compartment door, located on the left side of the front panel, to eject
the MSAM tray. A small hole can be found under the center of the MSAM door.
If needed, use a paper clip to pull the door out.
2
Place the MSAM card on top of the tray with the gold contacts facing down.
3
Align the MSAM tray properly into the compartment and gently push the tray
until it locks in place.
Make sure that the MSAM card sits firmly on the tray. The MSAM compartment will
not close properly if the MSAM card is installed incorrectly.
Figure 6
Inserting an MSAM Card
To manually startup and shutdown the VX 600, hold down on the power button,
depicted in
Figure
2.
Plug the wall-mount charger to an external power source and connect it to the VX
600 to charge the device.
Installing/Replacing MSAM Cards
VX 600
P
3G/3G
FOR THE I
HONE
D
S
EVICE
ETUP
17
I
G
S
NSTALLATION
UIDE
Advertisement
Table of Contents
