Installation Procedures; Warnings And Notes - Alcatel-Lucent 7705 Installation Manual

Installation Procedures

Installation Procedures

Warnings and Notes

Warning:
• Electrostatic discharge (ESD) damage can occur if adapter cards are mishandled. Always
• Always place components on a flat anti-static surface.
• For first-time power up during chassis installation, do not power up a 7705 SAR-8 until all
• Slot covers are required in all empty slots to prevent excess dust accumulation and to help
• To comply with the GR-1089-CORE requirement R4-9 [31] standard for electromagnetic
• The intra-building port(s) of the equipment or sub-assembly is suitable for connection to
Notes:
• Ports cannot be configured until the adapter card is provisioned.
• Services cannot be configured until the ports are configured.
• Adapter card slot numbers are MDA 1 through MDA 6.
• T1/DS1 terminations support 100-ohm impedance; E1 terminations support 75-ohm and
Page 18
wear an ESD-preventive wrist or ankle strap connected to a nearby ground point that is
connected to the site grounding point (typically, the grounding stud on the 7705 SAR-8, or
a properly grounded rack or work bench).
components are installed and verified as having been installed correctly.
control airflow and electromagnetic interference.
compatibility and safety, all intra-building ports are specified for use with shielded and
grounded cables at both ends.
intra-building or unexposed wiring or cabling only. The intra-building port(s) of the
equipment or sub-assembly must not be metallically connected to interfaces that connect to
the Outside Plant (OSP) or its wiring. These interfaces are designed for use as intra-
building interfaces only (Type 2 or Type 4 ports as described in GR-1089-CORE) and
require isolation from the exposed OSP cabling. The addition of primary protectors is not
sufficient protection in order to connect these interfaces metallically to OSP wiring.
120-ohm termination impedances.
16-port T1/E1 ASAP Adapter Card Installation Guide