Install Chute Rotation Gear - Ariens Sno-Thro Deluxe 24 Service Manual

1. Friction Plate
2. Chute Mount Bracket
4. Reinstall actuation gear bracket to pedestal plate and
secure with two tapping screws.
5. Reinstall chute rotation rod into chute gear and secure
with spring clip.
6. Reinstall chute gear cover and secure with tapping
screw.
7. Adjust discharge chute. Refer to Operator's Manual
for adjustment procedure.
8. Reconnect spark plug wire.
IMPORTANT: Check all adjustments after first use.

Install Chute Rotation Gear

Model 921326
IMPORTANT: Make sure discharge chute is positioned
forward.
See Figure 103.
1. Position actuation gear so gear teeth are at lowest
position.
2. Install chute rotation gear so midpoint of gear teeth is
seated in chute lock arm.
IMPORTANT: Make sure calibration markers on actuation
gear and chute rotation gear align.
1
Figure 102
2
1. Actuation Gear
2. Chute Rotation Gear
3. Chute Lock Arm
4. Calibration Markers
3. Secure chute rotation gear with one hex bolt, one
flange bushing and locking nut. See Figure 104.
4. Position chute rotation lever upright and discharge
chute facing forward.
EN – 43
1
3
2
Figure 103
Figure 104
4