Install Bearing To Right Side Of Unit - Ariens Sno-Thro Deluxe 24 Service Manual

See Figure 149.
11. Remove hardware retaining bearing flange(s) and
remove bearing(s).
IMPORTANT: Bearing plate is not a wear item and does
not need replacement unless damaged.
1. Bearing Flange
2. Bearing Plate

Install Bearing to Right Side of Unit

IMPORTANT: Bearing plates are ONLY installed with
bearing flanges on frame. Bearing plates are NOT installed
with bearings on side plates.
1. Install flange bearings and secure with three hex bolts
and three locking nuts. Tighten hardware.
2. Reinstall sleeve bushing between flange bearings on
side plate and frame.
See Figure 150.
3. Reinstall short axle until a small portion of axle is
through frame.
4. Reinstall two flat steel washers onto short axle.
5. Align differential gear with pinion gear and short axle
and reinstall axle into differential.
1
Figure 149
2
6. Reinstall long axle into differential gear. See
Figure 151.
7. Reinstall E-ring onto axle end.
8. Tighten six locking nuts securing mount plates to track
carriage.
9. Reinstall bottom cover and secure with six hex bolts.
Tighten hardware.
10. Reinstall track drive wheels. See Install Track Drive
Wheel on page 54.
11. Reinstall tracks. See Install Track on page 55.
12. Return unit to operating position.
13. Reconnect spark plug wire and fill fuel tank.
14. Adjust track tension. Refer to Operator's Manual for
adjustment procedure.
IMPORTANT: Check all adjustments after first use.
EN – 59
Figure 150
Figure 151