Sharp MX-2010U Technical Handy Manual page 40

TEST SIMULATION
55
MFP Data Setting
1 Engine soft switch setting
SW1-4 LSU polygon motor control:-
0 =Normal, 1 = Quiet mode
2 Scanner soft switch setting
SW8-1 Uncontaminated scan position
SW8-2 search (prevents lines):-
SW8-3 000 = Startup & Job Completion
001 = Startup only ON.
010 = Job completion only ON.
100 = OFF (Disabled)
3 Controller soft switch setting:-
SW1-5 Auto clear function before copy
job execution:-
0 =Disabled, 1 = Enabled
SW2-5 Custom size paper registration
for bypass tray:-
0 =Disabled, 1 = Enabled
SW3-6 Process mixed original size
printing for duplex mode:-
0 =Disabled, 1 = Enabled
SW3-7 HP Compatibility Mode:-
0 =Disabled, 1 = Enabled
SW4-5 Paper type simplification
selection:-
0 =Disabled, 1 = Enabled
SW4-7 Paper feed size entry:-
0 =Disabled, 1 = Enabled
SW5-1 Setting of HID Card Reader
SW5-2 support
SW5-3 (enable SW5, bits 1, 2 & 3)
0 =Disabled, 1 = Enabled
SW6-1 Ethernet Speed Auto
negotiation:-
0 = Enabled, 1 = Disabled
SW6-2 Ethernet Link Speed:-
0 = 100Base TX, 1 = 10Base T
SW6-3 Ethernet Duplex Mode:-
0 = Full, 1 = Half
SW6-4 Ethernet 100/1000 Link Speed:-
0 = 100Base TX, 1 = 1000Base T
SW6-8 Card Reader detection control
0 =Disabled, 1 = Enabled
SW9-5 Maintenance notification
setting by Printer MIB:-
0 = Enabled, 1 = Disabled
40
ON.
55
MFP Data Setting
3 Controller soft switch setting:-
SW22-5 Display toner remaining (MFP
Status):-
0= Disabled, 1 = Enabled/Display
SW22-7 LCD character display font:-
0 = Standard, 1 = Bold
SW24-7 Continuous print mode for OSA
(job queuing for external
accounting):-
0 = Job Queue Disabled
1 = Job Queue Enabled
SW27-7 Set printable area to same as
previous model
0 = CR3 series (Default)
1 = CR2 series
SW30-1 Change the colour of 2-line
message from Gradation
pattern to Single colour
0 = Gradation (Default)
1 = Single colour
56
MFP Data Import & Export
1 Transfer data execute
2 Export/Import Filing Data
3 Document filing data backup
4 Job log data backup
5 Export Adjustment & Settings data to USB
memory
60
Memory Operation & Test
1 SDRAM read/write test (ICU)
61
LSU Writing Adjustment/Test
1 LSU test (Polygon & BD detection check)
3 LSU power auto setup
4 LSU position adjustment (CMYK)
62
HDD Operation & Test
1 HDD format (FAT32)
2 HDD partial read/write check
3 HDD read/write check (all areas)
6 Smart (HDD) self diagnostics test
7 Smart (HDD) self diagnostics error log
8 HDD format (excluding system &
operation manual area)
10 Job completion list deletion (with job log)
SHARP