Connector For External Devices - Mitsubishi Electric MELSEC-L Series LD40PD01 User Manual

Connector for external devices

Precautions
• Tighten the connector screws within the specified tightening torque range.
Screw
Connector screw (M2.6)
• Use copper wires having temperature rating of 75 or more for the connectors.
• Use UL listed connectors if necessary for UL compliance.
Applicable connectors
Prepare connectors for external devices to be used with the flexible high-speed I/O control module by users.
The following table lists the applicable connectors, and the reference product of a crimping tool.
■40-pin connector
Type
Soldering type connector (Straight type)
Crimping type connector (Straight type)
Soldering type connector (Dual purpose (straight/oblique) type)
*1 When using 40 connectors, use wires whose sheath outside diameter is 1.3mm or less.
Select the wire applicable to the current value to be used.
The A6CON3 (IDC type connector (Straight type)) cannot be used.
■40-pin connector crimping tool
Type
Crimping tool
For how to wire connectors and how to use the crimping tool, contact FUJITSU COMPONENT LIMITED.
Wiring method
For the wiring method, refer to the following.
 MELSEC-L CPU Module User's Manual (Hardware Design, Maintenance and Inspection)
Tightening torque range
0.20 to 0.29N⋅m
Model
*1
A6CON1
A6CON2
*1
A6CON4
Model
FCN-363T-T005/H
Applicable wire size
2
0.088 to 0.3mm (28 to 22 AWG) (Stranded wire)
2
0.088 to 0.24mm (28 to 24 AWG) (Stranded wire)
2
0.088 to 0.3mm (28 to 22 AWG) (Stranded wire)
Contact
FUJITSU COMPONENT LIMITED
www.fcl.fujitsu.com/en
6 INSTALLATION AND EXTERNAL WIRING
6.2 External Wiring
6
41