Table of Contents
Advertisement
Connection Status
Connection Log
Connection Log
Buttons
Connect
Disconnect
Clear Log
Refresh
Connection Details - SingTel RAS
If using the SingTel RAS access method, a screen like the following example will be
displayed when the "Connection Details" button is clicked.
This indicates whether or not the connection is currently
established.
If the connection does not exist, the "Connect" button can
be used to establish a connection.
If the connection currently exists, the "Disconnect" button
can be used to break the connection.
Normally, it is not necessary to use the Connect and
Disconnect buttons unless the setting "Connect automati-
cally, as required" is disabled.
The Connection Log shows status messages relating to
the existing connection.
The Clear Log button will restart the Log, while the Re-
fresh button will update the messages shown on screen.
If not connected, establish a connection to Telstra Big Pond.
If connected to Telstra Big Pond, terminate the connection.
Delete all data currently in the Log. This will make it easier to
read new messages.
Update the data on screen.
Figure 31: Connection Details - RAS
Operation and Status
45
Advertisement
Table of Contents
