Planet XRT-411 User Manual page 11

3. Connect WAN Cable
Connect the DSL or Cable modem to the WAN port on the Broadband Router. Use
the cable supplied with your DSL/Cable modem. If no cable was supplied, use a
standard cable.
4. Connect Printer Cable
Use a standard USB printer cable to connect your printer to the USB Printer port
on the Broadband Router.
NOTE: GDI printers are not supported. Please refer to the CD for a list of GDI
printers. You can also check with the printer manufacturer.
5. Power Up
Power on the Cable or DSL modem.
Connect the supplied power adapter to the Broadband Router and power up.
Use only the power adapter provided. Using a different one may cause hardware
damage
6. Check the LEDs
The PWR LED should be ON.
The STATUS LED should flash, then turn Off. If it stays on, there is a hardware
error.
For each LAN (PC) connection, the LAN LNK/ACT LED should be ON (provided
the PC is also ON.)
The WAN LED should be ON.
The USB LED should be ON.
For more information, refer to Front-mounted LEDs in Chapter 1.
Introduction
7