Making Coffee Using Pre-Ground Coffee; Making Cappuccino; Cleaning The Cappuccino Maker After Use - DeLonghi ESAM 04.110 Instructions Manual

Please note:
For hotter coffee, see the section "10.4 Tips for a hotter coffee:".
Important!
• If the coffee is delivered a drop at a time, too weak and not
creamy enough or too cold, read the tips in the "19. TROU-
BLESHOOTING" section.
• Lights may be displayed on the control panel during use.
Their meaning is given in the sections "17. MEANING OF
LIGHTS DURING NORMAL OPERATION" and "18. MEANING
OF THE ALARM LIGHTS".

10.6 Making coffee using pre-ground coffee

Important!
• Never add pre-ground coffee when the machine is off or it
could spread through the inside of the machine and dirty
it. This could damage the appliance.
• Never use more than one level measure
or it could dirty the inside of the machine
or block the funnel.
Please note:
If you use pre-ground coffee, you can only make one cup of
coffee at a time.
1. Turn the coffee taste selection knob (B9) anticlockwise as
far as it will go to the
2. Make sure the funnel (A8) is not blocked, then add one
level measure of pre-ground coffee (A23) (fig. 13).
3. Place a cup under the coffee spouts (fig 9).
4. Press the cup coffee button (fig. 11).
5. Preparation begins and can be interrupted at any moment
by pressing one of the two coffee buttons (
-B5).
To deactivate the pre-ground coffee function, turn the knob to
one of the other positions.
Please note:
A few seconds may elapse between energy saving mode and
delivery of the first coffee.

11. MAKING CAPPUCCINO

Important! Danger of burns!
During preparation, steam is given off. Take care to avoid scalds.
1. When preparing cappuccino, make the coffee in a large
cup;
2. Fill a container with about 3,53 fl.oz/ 100 grams of milk for
each cappuccino to be made.
position.
-B3 or
In choosing the size of the container, bear in mind that the
milk doubles or triples in volume;
Please note:
For a richer denser froth, use skimmed or partially skimmed
milk at refrigerator temperature (about 41°F/ 5°C).
To avoid milk with poor froth or large bubbles, always clean
the cappuccino maker (A9) as described in the section

"11.1 Cleaning the cappuccino maker after use".

3. Press the button (B7). The corresponding light (B6)
flashes, indicating that the appliance is heating up;
5. Turn the cappuccino maker outwards and immerse in the
milk container (A9- fig. 14);
6. When the light stops flashing and comes on steadily,
turn the steam/hot water knob to the l position (B10 - fig.
5). Steam is delivered from the cappuccino maker, giving
the milk a creamy frothy appearance and making it more
voluminous;
7. For a creamier froth, rotate the container with slow move-
ments in an upward direction. (You should not discharge
steam for more than 3 minutes at a time);
8. When you have obtained the required froth, stop steam
delivery by turning the steam/hot water knob back to the
0 position.
Important! Danger of burns!
Always turn the steam/hot water knob to the 0 position
before removing the container with the frothed milk to
avoid burns caused by splashes of boiling milk.
9. Add the milk froth to the cup of coffee prepared previously.
The cappuccino is ready. Sweeten to taste and, if desired,
sprinkle the froth with a little cocoa powder.
Please note:
• If immediately after making cappuccino and deactivating
the steam function by pressing the steam button
you press the
you want to make another coffee, the coffee maker will be
too hot (the
indicate an unsuitable temperature). You must wait about
ten minutes for the appliance too cool down sufficiently.
To cool it down more quickly, after deactivating the steam
function, open the steam/hot water knob and let the water
flow out of the cappuccino maker into a container until the
lights and
Danger of burns!
Avoid contact with splashes of water.
12
(B3) or (B5) button because
and lights (B2 and B4) flash to
stop flashing.