Advertisement
device should be installed and operated at a
minimum distance of 20 cm between itself and your
body.
This device must not be co-located or operating in
conjunction with any other antenna or transmitter.
◆ Safety Notices
Read these instructions carefully before operating
the device. It is important to be aware of these safety
instructions. Install the device according to these
instructions and keep this guide for future reference.
• Do not use this device in a humid space, in the
rain, or near splashing water.
• Do not install during thunder or lightening storms.
• Do not cover any ventilation openings in the
device case.
• Do not place the device near heat sources such
as radiators or stoves.
• Clean the device only with a clean, dry cloth. Do
not use liquid or chemical cleaners.
• Avoid static discharge when touching the device
by first touching the coaxial connector of the
coaxial cable.
• The cable distribution system must be grounded
in accordance with ANSI/NFPA 70 and the
National Electrical Code (NEC), in particular
section
802.93,
Grounding
of
the
Conductive Shield of a Coaxial Cable.
◆
Installation Instructions
Use the following guidelines to install the device.
• For table mounting, place the device horizontally
on a stable surface.
• For wall mounting, use the mounting holes on the
bottom of the device, as shown in Figure 1.
Fasten two screws horizontally to the wall at a
distance of 19.4 cm (7.63"). Allow screws to
project from the wall so the device hangs securely
on the screws. See Figure 2 for recommended
screw size (D=5.0-5.5, H=1.8-2.2, L=8.2-9.0,
E=2.9-3.0).
Figure 1. Distance Between Mounting Holes
Outer
2
Advertisement
