Exterior Lamps Off Reminder; Headlamp High/Low-Beam; Changer - Cadillac CT6 2017 Owner's Manual

164 LIGHTING
To enable the IntelliBeam system,
press the button on the end of the
turn signal lever when the exterior
lamp control is in the AUTO or
position. The blue high-beam on light
appears on the instrument cluster
when the high beams are on.
Driving with IntelliBeam
The system only activates the high
beams when driving over 40 km/h
(25 mph).
There is a sensor near the top center
of the windshield that automatically
controls the system. Keep this area of
the windshield clear of debris to allow
for best system performance.
The high-beam headlamps remain on,
under the automatic control, until one
of the following situations occurs:
The system detects an
approaching vehicle's headlamps.
The system detects a preceding
vehicle's taillamps.
The outside light is bright enough
that high-beam headlamps are not
required.
The vehicle's speed drops below
20 km/h (12 mph).
The IntelliBeam system is disabled
by the high/low-beam changer or
the flash-to pass feature. If this
happens, press the button on the
end of the turn signal lever to
reactivate the IntelliBeam system.
The instrument cluster light will
come on to indicate the
IntelliBeam is reactivated. See
Headlamp High/Low-Beam Changer
0 164 and Flash-to-Pass 0 165.
The high beams may not turn off
automatically if the system cannot
detect another vehicle's lamps because
of any of the following:
The other vehicle's lamps are
missing, damaged, obstructed from
view, or otherwise undetected.
The other vehicle's lamps are
covered with dirt, snow, and/or
road spray.
The other vehicle's lamps cannot
be detected due to dense exhaust,
smoke, fog, snow, road spray, mist,
or other airborne obstructions.
The vehicle's windshield is dirty,
cracked, or obstructed by
something that blocks the view of
the light sensor.
The vehicle is loaded such that the
front end points upward, causing
the light sensor to aim high and
not detect headlamps and
taillamps.
Driving on winding or hilly roads.
The automatic high-beam headlamps
may need to be disabled if any of the
above conditions exist.
Exterior Lamps Off
Reminder
A warning chime sounds if the driver
door is opened while the ignition is off
and the exterior lamps are on.

Headlamp High/Low-Beam

Changer

: Push the turn signal lever away
from you and release, to turn the high
beams on. To return to low beams,
push the lever again or pull it toward
you and release.