Other Trouble Displays - ADEMCO Security System VISTA-10SE User Manual

TROUBLE CONDITIONS (Continued)
Words or letters in parentheses (
Other Trouble 1. COMM. FAILURE
Displays
*
Any "beeping" that
2. SYSTEM LO BAT
accompanies a
trouble display can be
stopped by entering
an OFF sequence
(code + OFF)
3. LO BAT + zone descriptor
**
Not all systems use
wireless transmitters.
4. MODEM COMM
(or FC)
(or BAT with no zone No.)
(or BAT with zone No.)
(or CC)
–
) are those that are displayed on Fixed-word keypads.
Indicates that a failure has occurred in the telephone com-
munication portion of your system.
CALL FOR SERVICE IMMEDIATELY.
Indicates that a low system battery condition exists, and
accompanied by a once-per-minute "beeping"* at the
Keypad. If this condition persists for more than one day
(with AC present), CALL FOR SERVICE.
Indicates that a low battery condition exists in the wireless
transmitter** number displayed, and accompanied by a
once-per-minute "beeping"* at the Keypad. Either replace
the battery yourself, or CALL FOR SERVICE. If the battery
is not replaced within 30 days, a CHECK display may
occur.
Some wireless sensors contain a non-replaceable long-life
battery which requires replacement of the entire unit at the
end of battery life (e.g., 5802 Pendant and 5802CP Belt
Clip Personal Emergency Transmitters and 5803 Wireless
Key Transmitters).
Indicates that the control is on-line with the central station's
remote computer. The control will not operate while on-
line. Wait a few minutes. The display should disappear.
–
2 7