Emerson Fisher 4200 Instruction Manual page 38

4200 Transmitters
March 2011
Figure 17. Typical Transmitter Mounting on Fisher 585C or 585CR Actuator
37B4775‐A / DOC
Parts for Mounting the Transmitter on 585
or 585C Actuators (figures 16 and 17)
Key Description
12 Machine Screw, pl steel (2 req'd)
585 & 585R only
21 Mounting Plate, steel
585C and 585CR
585 and 585R
Size 25, 50
Size 100
23 Cap Screw, zn pl steel
585 and 585R (4 req'd)
585C and 585CR (2 req'd)
24 Washer, (2 req'd)
585C and 585CR only
25 Operating Arm, pl steel
26 Cap Screw, pl steel
27 Square Nut, pl steel
29 Torsional Spring, zn pl steel
30 Lever Assembly
Size 100 w/ 0.75 thru 2.125 inch travel
Size 100 w/ 2.5 thru 4 inch travel
38
Key Description
Note
The lever assembly, key 30, is not used with size 25 and 50 actuators.
Individual parts below (key 30A through 30C) are needed.
30A Lever/Bearing Assembly
30B Transfer Pin, stainless steel
30C Pickup Pin, stainless steel
31 Shoulder Screw, stainless steel
32 Hex Cap Screw, pl steel (2 req'd)
33 Stem Bracket
585C and 585CR only
Size 25
Size 50
36 Sleeve, acetal
40 Positioner Bracket, zn pl steel
585 and 585R only
Size 25, 50
Size 100
83 Lockwasher (2 req'd)
585C and 585CR only
Instruction Manual
D200354X012