Cisco IR829 Hardware Installation Manual page 44

Installing the Router
Figure 2-3
Step 2 Install the router to a wall stud using two number-10 wood screws, round- or pan-head, with number-10
washers or two number-10 washer-head screws. The screws must be long enough to penetrate at least 1.0
inch (25.4 mm) into the supporting wood or metal wall stud. (See
Figure 2-4
For hollow-wall mounting, each bracket requires two wall anchors with washers. Wall anchors and
Note
washers must be size number 10.
Route the cables so that they do not put a strain on the connectors or mounting hardware. Cables should
Step 3
be routed down relative to the router to prevent water from traveling on the cables.
Cisco IR829 Integrated Services Router Hardware Installation Guide
2-6
Cisco IR829 Mounting Holes
Mounted to wall
Chapter 2 Installing the Router
Figure 2-4.)