Cisco IR829 Hardware Installation Manual page 21

Chapter 1 Product Overview
Table 1-1
LED
GPS
MOD
Ethernet LAN
Switch Ports
GE1-GE4]
Single LED per
Port
WLAN
CELLULAR0/
CELLULAR1
CELLULAR0/
CELLULAR1
SIM0/SIM1
Figure 1-7
LED Descriptions (continued)
Activity
GPS Status
Link Status/POE Status Off — No link
2.4GHz
5GHz
ACT
RSSI
Sim cards
RSSI LED
RSSI RSSI (2)
Green
<110dBm Off
-110 — 90dBm Off
Cisco IR829 Integrated Services Router Hardware Installation Guide
Description
Off — GPS not configured
On — GPS configured
Slow Flash — GPS Acquiring in Standalone GPS
Fast Flash — GPS Acquiring in Assisted GPS
Slow Flash is defined as the LED will be on for
Note
0.25 seconds and off for 0.75 seconds.
Fast Flash s defined as the LED will be on for
0.25 seconds and off for 0.25 seconds.
Green Steady on — Link is up
Green Blink — Transmitting and Receiving data
Yellow — POE Fault, implies no link
Off — Radio is down (no SSID configured)
Flashing Green — Bootloader, IOS Ethernet
Initialization, IOS Start Up after system initialization.
Green to Red to Yellow — Discovery/Join process.
Rapid Flashing Green — Joined to a controller
Steady Green — One wireless client is associated.
Off — Module not powered on
On — Module is powered on and connected but not
transmitting or receiving
Slow Blink — Module is powered on and searching for
connection
Fast Blink — Module is transmitting or receiving.
The RSSI LEDs are a 3 LED bar graph to indicate signal
strength. Their functionality is described in the RSSI LED
figure below.
Off — No USIM
Green — USIM installed and active
RSSI (1)
Green
Off
Off
General Description
RSSI (0)
Green/Yellow
Off
On - Yellow
1-5