Leds - Cisco IR829 Hardware Installation Manual

General Description
Figure 1-6
The following section shows a detailed description of the LEDs.

LEDs

The following table describes the LEDs for the Cisco IR829.
Table 1-1
LED
PWR
POE
VPN
GE0 WAN
Cisco IR829 Integrated Services Router Hardware Installation Guide
1-4
Cisco IR829 LED Detail
LED Descriptions
Activity
Power Status
POE Power Supply
Status
VPN
Link Status
Description
Off — No power
Green Steady on — Normal operation
Green Flashing — Boot up phase or in ROM Monitor
mode
Yellow Steady on — System shutdown due to under or
over voltage conditions
Yellow Flashing — System has an error, but has network
connectivity
Off — No -54V PoE power supply detected or no PoE
board installed
Green Steady on — 53.5V POE power supply good and
all powered port operating normally
Yellow Steady on — 53.5V POE power supply good, but
one or more POE ports has a fault.
Off — No VPN tunnel
Steady on — At least one VPN tunnel is up
Off — No link
Steady on — Link is up
Blink — Transmitting and Receiving data
Chapter 1 Product Overview