Cisco IR829 Hardware Installation Manual page 39

Installing the Router
This chapter describes the equipment and the procedures for successfully installing the Cisco IR829 and
contains the following sections:
Equipment, Tools, and Connections, page 2-2
•
Installing the Router, page 2-3
•
Do not place anything on top of the router that weighs more than 10 pounds (4.5 kilograms), and do not
Caution
stack routers on a desktop. Excessive weight on top of the router could damage the chassis.
Caution Do not install the router or power supplies next to a heat source of any kind, including heating vents.
Warning Read the installation instructions before connecting the system to the power source. Statement 1004
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
No user-serviceable parts inside. Do not open. Statement 1073
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Statement 1040
Warning Do not locate the antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, because they may cause serious injury or death. For
proper installation and grounding of the antenna, please refer to national and local codes (for
example, U.S.:NFPA 70, National Electrical Code, Article 810, Canada: Canadian Electrical Code,
Section 54). Statement 1052
C H A P T E R
Cisco IR829 Integrated Services Router Hardware Installation Guide
2
2-1