Cisco IR829 Hardware Installation Manual page 15

Preface
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
Warning
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
If the symbol of suitability with an overlaid cross appears above a port, you must not connect the port
Warning
to a public network that follows the European Union standards. Connecting the port to this type of
public network can cause severe personal injury or can damage the unit. Statement 1031
Connect the unit only to DC power source that complies with the safety extra-low voltage (SELV)
Warning
requirements in IEC 60950 based safety standards. Statement 1033
Warning When installing or replacing the unit, the ground connection must always be made first and
disconnected last. Statement 1046
Warning Do not locate the antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, because they may cause serious injury or death. For
proper installation and grounding of the antenna, please refer to national and local codes (for
example, U.S.:NFPA 70, National Electrical Code, Article 810, Canada: Canadian Electrical Code,
Section 54). Statement 1052
No user-serviceable parts inside. Do not open. Statement 1073
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Read the installation instructions before connecting the system to the power source. Statement 1004
Warning
Warning Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning The covers are an integral part of the safety design of the product. Do not operate the unit without the
covers installed. Statement 1077
Cisco 829 Integrated Services Router Hardware Installation Guide
9