Fuji Xerox DocuPrint CP405 d User Manual page 16

3
Click [Run Launcher.exe].
NOTE:
• If the [User Account Control] dialog box appears, click [Yes] to continue the installation.
The [PostScript Printer Driver Version Check Tool] dialog box is displayed.
4
Click [Next] and follow the on-screen instructions until the [Setup] screen of the "Driver Installation Tool" is
displayed.
5
Click [Standard].
The [Printer Selection] screen is displayed.
Printers connected to LPD and TCP/IP within the same subnet are detected, and a list is displayed in [Printers
found].
6
From [Printers found], select the model to be used.
NOTE:
• Available printers are selected with a check mark.
• If the model to be used is not detected, confirm as follows.
IP address of printer
You can confirm the IP address of the printer by printing a System Settings page (for the DocuPrint CM405 df) or Printer
Settings page (for the DocuPrint CP405 d). For details, refer to the manual contained in the Driver CD Kit.
Whether the SNMP UDP/IP port is enabled
If the model to be used is still not detected, click [Back], [Custom] and proceed with the installation.
For details about [Custom], see:
Installing Printers Connected to a TCP/IP Network on page 17
Installing Printers Connected to a Windows Network on page 18
Installing Shared Printers on a Windows Server on page 19
Using Existing Ports and Installing on page 20
Installing Local Printers on page 22
You can select multiple printers.
Confirm the IP addresses and names of the models displayed, and select the printers to install. When selecting printers
displayed in the list in [Printers found], a printer graphic is displayed at the left side.
7
Click [Next].
The [Software License Agreement] screen is displayed.
8
Read through the license agreement carefully and if you have no objections to it, select [Yes], and then click
[Install].
Installation begins.
The graphic of the printer being added, and the address or model name of the printer being installed are
displayed.
When setup completes, the [Setup Complete] screen is displayed.
9
From the [Printer Installed] list, select one model and click [Properties].
The printer's [Properties] dialog box is displayed.
10
Select the [Configuration] tab, set the option settings, and click [OK] to close the [Properties] dialog box.
For details about option settings, see Configuration Tab Settings on page 48.
NOTE:
• If you install multiple printers, be sure to set the option settings for each printer by repeating the steps 9 and 10.
11
Click [Test Page].
The test print page is printed from the printer.
12
Click [Finish].
A confirmation message is displayed.
16
Installing of Print Drivers for Windows Computers