Planar Dome EX User Manual page 44

34 | Dome EX Display
-s
-f1<path\response file>
-f2<path\log file>
-remove
-bit8
-bit32
-static
-notstatic
-yesddraw
-noddraw
-autodetect
-noautodetect
Silent mode. Use a response file instead
of prompting user response during
installation.
Use the response file specified during
installation. If no -f1 switch is given, the
installation uses the response file in the
same directory in which setup.exe
resides.
Save any output to the log file specified
during installation. If no -f2 switch is
given, the installation saves to the log
file in the same directory in which the
response file resides. This may cause
a problem if setup is run from the CD-
ROM drive.
Run uninstallation.
Set all Dome CX or Dome EX displays to
8-bit mode (default).
Set all Dome CX or Dome EX displays to
32-bit mode. Grayscale switches are
ignored when this switch is specified.
Set 8-bit mode to static gray palette
(default).
Set 8-bit mode to dynamic gray palette.
Enable DirectDraw (default).
Disable DirectDraw.
Enable AutoOrientation for Dome EX
displays (default).
Set all displays to portrait orientation.