Planar Dome EX User Manual page 20

10 | Dome EX Display
Install the Dome DX Display Driver
Before you install the driver, remove any previously installed display
driver for the display controller from your system.
To install the driver
1 Log on with administrator privileges. The InstallShield Wizard
reports new hardware.
2 Click Cancel. You must run Setup.exe to install the driver.
3 Insert the W2KDXPCI CD and open the CD folder.
4 Double-click Setup.exe.
5 Click Next to proceed and start copying files.
6 If the Digital Signature Not Found message appears, click Yes or
Continue to complete the driver installation.
7 Select Yes, I want to restart my computer now, and click Finish.
To enable the display
1 Log on with administrator privileges.
2 Right-click the desktop. Select Properties > Settings.
3 Select the display icon.
4 Select Extend my Windows desktop onto this monitor. Click Apply.
5 Click OK.
To change the display properties
Use the Dome tab to change display properties after the Dome EX
display is attached to the Windows desktop. Otherwise, use
Properties > Settings tab.
To determine screen assignments
Click Identify in the Settings tab to match screens to display
controllers. (Windows 2000 renumbers and reassigns screens as you
add them to the configuration. Set resolutions or preferences only
after all display controller and screens are installed. Restart your
system to make sure the screen assignments are retained.)