Cisco XR 12000 Series Configuration Manual page 40

How to Implement Multicast Routing
11.
12.
13.
14.
15.
16.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/0/CPU0:router# configure
Step 2
router pim [address-family {ipv4 | ipv6}]
Example:
RP/0/0/CPU0:router(config)# router pim
Step 3
bsr candidate-bsr ip-address [hash-mask-len
length] [priority value]
Example:
RP/0/0/CPU0:router(config-pim-default-ipv4)#
bsr candidate-bsr 10.0.0.1 hash-mask-len 30
Step 4
bsr candidate-rp ip-address [group-list
access-list] [interval seconds] [priority
value]
Example:
RP/0/0/CPU0:router(config-pim-default-ipv4)#
bsr candidate-rp 172.16.0.0 group-list 4
Step 5
interface type interface-path-id
Example:
RP/0/0/CPU0:router(config-pim-default-ipv4)#
interface GigE 0/1/0/0
Step 6
bsr-border
Example:
RP/0/0/CPU0:router(config-pim-ipv4-if)#
bsr-border
Multicast Configuration Guide
MCC-32
or
[sequence-number] permit source-prefix dest-prefix
end
or
commit
clear pim [vrf vrf-name] [ipv4 | ipv6] bsr
show pim [vrf vrf-name] [ipv4 | ipv6] bsr candidate-rp
show pim [vrf vrf-name] [ipv4 | ipv6] bsr election
show pim [vrf vrf-name] [ipv4 | ipv6] bsr rp-cache
show pim [vrf vrf-name] [ipv4 | ipv6] group-map [ip-address-name] [info-source]
Implementing Multicast Routing on Cisco IOS XR Software Cisco ASR 9000 Series Routers
Purpose
Enters global configuration mode.
Enters PIM configuration mode, or address-family
configuration submode.
Configures the router to announce its candidacy as a BSR.
Configures the router to advertise itself as a PIM Version 2
candidate RP to the BSR.
See Step 9
•
(Optional) Enters interface configuration mode for the PIM
protocol.
(Optional) Stops the forwarding of bootstrap router (BSR)
messages on a Protocol Independent Multicast (PIM) router
interface.
for group list 4 configuration.
OL-